Setting
Two modes of plate figure such as the third part AC and DC line as shown
in figure.
When the unit is connected to the power source, it responds
immediately by showing an introductory screen as follows：
The setting process consists of the following steps:
1) Connecting the energy source.
2) Configuration process (PLC definition).
3) Connecting the input/output devices.
4) Testing solenoids
1) Connecting the energy source.
2) Configuration process (PLC definition).
3) Connecting the input/output devices.
4) Testing solenoids
CONNECTING THE ENERGY SOURCE
Before setting FILTRON16, the equipment required to properly connect to the power supply. If it is AC model, the equipment should be connected to
the right power according to requirement .Before setting FILTRON16, the equipment required to properly connect to the power supply. If it is AC model, the equipment should be connected to
Two modes of plate figure such as the third part AC and DC line as shown
in figure.
NOTE： when it is DC model, avoid to miss put the positive and negative
lines in the opposite position.
lines in the opposite position.
When the unit is connected to the power source, it responds
immediately by showing an introductory screen as follows：
For more information or enquiry, please contact Environmech Sdn. Bhd.
Contact us: http://www.environmech.com/p/contact-us.html
Website: www.Environmech.com
