Initial Installation & Operation
General
The filter assembly is protectively packed on a wood pallet with all parts assembled include
the control panel (with 5 meter cable installed).
Installation (Figure 2)
1. Remove the filter assembly from the wood pallet.
2. Install the filter assembly to the inlet line and outlet line.
3. Connect a drain pipe to the hydraulic CLEANING valve outlet opening (at least 50 mm
diameter and 15 m long). Confirm that water runs freely out of the drain pipe.
4. Position the control panel in such a way as to be protected against humidity and solar
radiation (if required a longer cable then the installed 5 meter – reconnect it by authorized electrician).
5. Check that all connections are properly secured.
6. Check that all bolts and nuts on the filter periphery are properly tightened and secured.
General
The filter assembly is protectively packed on a wood pallet with all parts assembled include
the control panel (with 5 meter cable installed).
Installation (Figure 2)
1. Remove the filter assembly from the wood pallet.
2. Install the filter assembly to the inlet line and outlet line.
3. Connect a drain pipe to the hydraulic CLEANING valve outlet opening (at least 50 mm
diameter and 15 m long). Confirm that water runs freely out of the drain pipe.
4. Position the control panel in such a way as to be protected against humidity and solar
radiation (if required a longer cable then the installed 5 meter – reconnect it by authorized electrician).
5. Check that all connections are properly secured.
6. Check that all bolts and nuts on the filter periphery are properly tightened and secured.
For more information or enquiry, please contact Environmech Sdn. Bhd.
Contact us: http://www.environmech.com/p/contact-us.html
